When stopping the docker the cpu dropped to ~2-7% instead of permanent 40-100% over all 4 cores. First test Plex was not successful, but luckily the second try with pgadmin4 did the trick. Then I suspected docker (not runninv VMs currently). And the user was 5050 (and the only process using it, which baffled me). I just updated unraid from 6.9.2 to 6.10.2 and could not figure out why at least one CPU core was stuck at 100%! Did check terminal -> top and could only see COMMAND "gunicorn"- which I could not find anything related to unraid with google. When you get a terminal window, set the permissions on the pgadmin4 folder as follows YOU MUST DO THE FOLLOWING IN ORDER TO RUN THIS DOCKER: After the container has been started for the first time these variables can be removed from the template.Īll other configuration for the container can be found in the pgAdmin docs. The email is not actually used, it's just a username. You must provide values for Default Email and Default Password in the template or the container will not start. If you use this approach you can safely ignore or remove the Email/Password variables from the template. If you are migrating from fenglc just use the same folder from appdata. Use the Config path (under "Show More Settings") in the template to map your working directory. = Migrating from fenglc or bringing your own data = NOTE: On initial container build there may be a noticeable delay (10-20 seconds) between when the container starts and when the UI becomes available. Then run this command from the unraid cli (terminal window) to configure ownership:Ĭhown -R 5050:5050 /mnt/user/appdata/pgadmin4 Either create the directory manually (defaults to /mnt/user/appdata/pgadmin4) or wait for the container to create it on initial start. This is due to pgadmin using a non-root user inside the container for operations. Regardless of existing or new installation you MUST configure ownership for the directory mapped to appdata under the Config setting in the template.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |